Rancang Bangun Sistem Proteksi Over dan Under Voltage Secara Otomatis Menggunakan Modul Deep Sea 4520
DOI:
https://doi.org/10.32493/yepei.v3i2.54440Abstract
In companies that require a continuous and uninterrupted supply of electrical energy, a generator with sufficient capacity to meet the needs of an industry or with a large capacity is essential. Since the electricity supply must not be interrupted, a device has been developed to automatically back up the system in the event of a problem. In this case, the deep-sea electronics 4520 module is used for monitoring. This research is an experimental study. The data collected consists of tests and verifications aimed at obtaining facts and characteristics related to a particular issue. In this case, observations were made on the protection panel system to assess its suitability and capability in backing up 2 kWh. The parameters observed include frequency, current, voltage, and power, during tests with loads monitored through the deep-sea electronics 4520 module. During the load test, the power difference observed using the deep-sea electronics 4520 module and the Avometer was very slight. The current produced during the test with a 900W load was 4A. The voltage used was 220V. The cos φ value obtained was 0.97. Since the cos φ value used was 0.97 rather than 1, there was a slight difference in the calculated power output between the deep-sea electronics 4520 module and the Avometer. The frequency obtained from the load testing, ranging from 200 W to 900W, was 50.1Hz. The lowest voltage is 209V, the highest voltage is 236V. Load testing of 900W. The resulting current is 4A. The protection panel is able to perform its duties well when backing up. The results from the deep-sea electronics 4520 module are 50.1Hz for frequency, and cos φ is 0.97.
Keywords: protection panel; low voltage; overvoltage, deep sea electronics
Abstrak
Pada lingkup perusahaan yang mewajibkan ketersediaan energi listrik secara terus menerus dan tidak boleh terputus, maka sangat dibutuhkan genset dengan kapasitas yang memenuhi kebutuhan suatu industri atau memiliki kapasitas besar. Karena listrik tidak boleh putus maka dibuatlah alat untuk otomatis memback-up saat terjadi kendala. Dalam hal ini digunakan modul deep sea electronics 4520 untuk melakukan pengamatan pada penelitian jenis eksperimen. Pengambilan data berupa pengujian dan pembuktian yang bertujuan untuk mendapatkan fakta serta sifat mengenai suatu permasalahan. Dalam hal ini dilakukan pengamatan pada sistem panel proteksi untuk mengetahui kelayakan serta kesanggupan dalam memback-up 2kWh. Hal yang diamati adalah frekuensi, arus, tegangan, daya, dalam uji coba dengan beban yang diamati melalui modul deep sea electronics 4520. Pada saat pengujian dengan beban perbedaan daya yang dihasilkan melalui pengamatan dengan modul deep sea electronics 4520 dan Avometer berbeda sangat tipis, Ampere yang dihasilkan saat melakukan uji coba dengan beban 900W adalah 4A. Tegangan yang digunakan 220V. Cos φ yang dihasilkan 0.97. Dikarenakan cos φ yang digunakan 0.97 bukan 1 maka ada sedikit perbedaan daya hasil perhitungan antara modul deep sea electronics 4520 dan Avometer. Frekuensi yang dihasilkan dari uji coba dengan beban baik 200W hingga 900W adalah 50.1Hz. Tegangan terendah adalah 209V, tegangan tertinggi 236V. Uji coba beban 900W. Ampere yang dihasilkan adalah 4A. Panel proteksi mampu menjalankan tugas dengan baik saat memback-up. Hasil dari modul deep sea electronics 4520 adalah 50.1Hz untuk frekuensi, dan cos φ adalah 0.97.
Kata Kunci: panel proteksi, tegangan rendah; tegangan berlebih, deep sea electronics
Downloads
Published
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Journal of Young Electrical Power and Electronics Implementation adheres to Attribution-ShareAlike 4.0 International license.
Journal of Young Electrical Power and Electronics Implementation menganut lisensi Atribusi-BerbagiSerupa 4.0 Internasional.

.png)

